Concrete, gypsum and eco 3D print.
Three materials, each cast or printed in our own studio. They give a different feel, a different finish and a wide range of color, so the object can match exactly what your brief needs.
Concrete
Cast, hand-finishedOur concrete is a fine-grained cement blend, dense and smooth, cast from custom molds and finished by hand. It pigments well across soft greys, warm earth tones, deep charcoal and saturated brand colors.
Because it is poured and finished by hand, the surface carries a fine natural texture and each piece comes out a little its own. We treat that as the point, not a flaw: a hand-cast object reads as made, not stamped out. Within a single run we hold color and finish as close as hand casting allows, so a batch sits together as a set.
Gypsum
Matte, fine detailGypsum gives a soft matte surface that holds fine detail and takes pigment beautifully, from clean white to pastels and richer tones. It suits smaller, more delicate pieces where crisp edges matter.
Like concrete, it is cast by hand, so texture and engraving carry small natural variations from piece to piece. Each object is finished individually and checked before it ships.
3D print
Eco PLA, custom geometryWe print in eco-friendly PLA, a plant-based material, for lighting, holders and shapes a mold cannot form. Printing lets us build the logo into the model itself, raised in relief or recessed as part of the object.
Printed surfaces show fine print lines, which we treat as part of the material's character rather than hide. Where a piece needs a perfectly smooth face, concrete or gypsum is usually the better route, and we will tell you which fits your brief.
Tinted to your brand, finished by hand.
Pigment is mixed into the material, so the color runs all the way through rather than sitting on top. Across a run we match it as closely as hand casting allows. Up close, the small natural variation in tone and texture is what tells a client the piece was made by hand, not pressed off a line.
See branding optionsThree ways to put your brand on the material.
Engraving
Laser-engraved into concrete or gypsum, incised and slightly darker than the surface around it. Engraving picks up the material's own texture, so each mark is crisp and a little unique.
Built-in relief
On custom pieces we plan the logo into the mold at the design stage, raised or recessed as part of the form. It cannot peel or wear off because it is the object.
Color
We pigment concrete and gypsum across a wide range, from neutral tones to your brand color, mixed in rather than painted on.
Not sure which material fits?
Tell us what you want made and how it will be used. We will recommend the material, finish and branding method that suits the piece, and reply with a ballpark within one business day.